Slicer Discord
Ant Trap – 3D-Druckmodell von Thingiverse Thingiverse

Ant Trap

von nobeer
35 Downloads
29 Likes
0 Makes
Zum Modell
This is an ant trap for the tiny house ants. Put a pea size drop of honey and equal amount of borax in the middle of the trap body and mix together. Screw the lid on. Place lid-up where the ants like to walk.

You may add a tiny dab of honey on one of the holes to invite the ants inside.

Ants should start to gather in a large crowd around the container. Wait for about 12-24 hours. The ants will be gone.

If the ants walk on a wall, you can scotch the container to the wall. To prevent honey from flowing out, use a little scotch tape inside and orient the container using the small bump on the side of the container.

I've made a second container that is easier to attach to the wall and that has a protection to prevent the honey from flowing out.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Ca. Druckzeit
24 h
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen