Slicer Discord
Ant Trap – Modelo 3D imprimible de Thingiverse Thingiverse

Ant Trap

por nobeer
35 Descargas
29 Likes
0 Makes
Ver Modelo
This is an ant trap for the tiny house ants. Put a pea size drop of honey and equal amount of borax in the middle of the trap body and mix together. Screw the lid on. Place lid-up where the ants like to walk.

You may add a tiny dab of honey on one of the holes to invite the ants inside.

Ants should start to gather in a large crowd around the container. Wait for about 12-24 hours. The ants will be gone.

If the ants walk on a wall, you can scotch the container to the wall. To prevent honey from flowing out, use a little scotch tape inside and orient the container using the small bump on the side of the container.

I've made a second container that is easier to attach to the wall and that has a protection to prevent the honey from flowing out.
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Tiempo estimado
24 h
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección