Thingiverse
APIDEA locking device
von WinsFromPirath
17
Downloads
11
Likes
0
Makes
I addet the device to an Rütli Begattungskasten from Holtermann which should be the same like the Apidea one.
After the printing is done, drill a 1mm hole in the slider and press a piece of a nail into the hole.
It´s not nessesary to glue the rail into the hard foam, it tightly fits.
After the printing is done, drill a 1mm hole in the slider and press a piece of a nail into the hole.
It´s not nessesary to glue the rail into the hard foam, it tightly fits.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
