Thingiverse
APIDEA locking device
17
Downloads
11
Likes
0
Makes
I addet the device to an Rütli Begattungskasten from Holtermann which should be the same like the Apidea one.
After the printing is done, drill a 1mm hole in the slider and press a piece of a nail into the hole.
It´s not nessesary to glue the rail into the hard foam, it tightly fits.
After the printing is done, drill a 1mm hole in the slider and press a piece of a nail into the hole.
It´s not nessesary to glue the rail into the hard foam, it tightly fits.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
