Thingiverse
AR Upper Vice Block
von holydeltawings
377
Downloads
144
Likes
1
Makes
This is an AR15 upper vice block for assembly.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
holydeltawings veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
