Thingiverse
AR Upper Vice Block
por holydeltawings
377
Descargas
144
Likes
1
Makes
This is an AR15 upper vice block for assembly.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
holydeltawings también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
