Thingiverse
Basic Filament Filter
von markd15
52
Downloads
21
Likes
1
Makes
This is a simple filament filter I threw together. It's clunky and heavy, but it gets the job done.
I would recommend PETG to avoid snapping the little catch on the front. Print the parts solid and lying on their largest faces. One model is already in this position and the other will need to be turned over.
The hinge is an 1/8" metal dowel pin.
The filter material is two pieces of foam cut approximately 30x15x7.5mm.
I would recommend PETG to avoid snapping the little catch on the front. Print the parts solid and lying on their largest faces. One model is already in this position and the other will need to be turned over.
The hinge is an 1/8" metal dowel pin.
The filter material is two pieces of foam cut approximately 30x15x7.5mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
