Thingiverse
Bed Adhesion Test
by mikeneron
33
Downloads
15
Likes
1
Makes
Pretty simple cylinder. Good test to see how well your prints stick to the bed.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
mikeneron also publishes on
29 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
