Thingiverse
Bed Adhesion Test
door mikeneron
33
Downloads
15
Likes
1
Makes
Pretty simple cylinder. Good test to see how well your prints stick to the bed.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
mikeneron publiceert ook op
29 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
