Thingiverse
Bed Adhesion Test
por mikeneron
33
Descargas
15
Likes
1
Makes
Pretty simple cylinder. Good test to see how well your prints stick to the bed.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
Use the 40mm tall one to test various temperature settings and/or other settings until you find the one that sticks nice and firm to the bed after the print has finished. Once you have found the best setting, try the 100mm tall one. If it's still standing at the end of the print, your bed adhesion is good.
Mine stuck just fine using an Ikea mirror...no tape, glue, hairspray, etc. I find that 70C for the first layer and then 60C after that works the best for me with PLA.
mikeneron también publica en
29 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
