Thingiverse
Bed level test
von DuckTheSam
1
Downloads
1
Likes
0
Makes
Info:
1) Be at the printer and watch it print.
2) You want the filament to just glide out and not drop down
3) If it drops, you want to higher the build area.
Print time: 6 minutes (MAX)
Tips:
If your print keeps falling off, try to lower the bed heat. I had the problem and then i made this file and lowered the bed heat, now it runs smoothly with no problems.
Check the Build Plate adhesion image and try to print with that.
1) Be at the printer and watch it print.
2) You want the filament to just glide out and not drop down
3) If it drops, you want to higher the build area.
Print time: 6 minutes (MAX)
Tips:
If your print keeps falling off, try to lower the bed heat. I had the problem and then i made this file and lowered the bed heat, now it runs smoothly with no problems.
Check the Build Plate adhesion image and try to print with that.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
