Thingiverse
BLTouch Tester
von cmshelton1961
1
Downloads
1
Likes
0
Makes
Tester box made to test my bltouch prob off the 3d printer when I have issues
three different bottoms,
box using screws to hold Arduino Nano
box with spring latch (spring from a ink pen about18-20mm long, takes tweezers to install)
box with sliding latch.
boxes with latches......
spring latch slides in from back side, after inserted us a 3mm wide 6 to 10 mm long screw threw hole to hold spring, screw goes inside spring
slider box slides in from Arduino Nano side. use 3mm wide 6 to 10 mm long screw, slide to latch Nano and snug the screw to hold.
Program to upload to Arduino Nano
https://github.com/knud/BLTouchTest/blob/master/BLTouchTest.ino
three different bottoms,
box using screws to hold Arduino Nano
box with spring latch (spring from a ink pen about18-20mm long, takes tweezers to install)
box with sliding latch.
boxes with latches......
spring latch slides in from back side, after inserted us a 3mm wide 6 to 10 mm long screw threw hole to hold spring, screw goes inside spring
slider box slides in from Arduino Nano side. use 3mm wide 6 to 10 mm long screw, slide to latch Nano and snug the screw to hold.
Program to upload to Arduino Nano
https://github.com/knud/BLTouchTest/blob/master/BLTouchTest.ino
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
