BLTouch Tester

Tester box made to test my bltouch prob off the 3d printer when I have issues

three different bottoms,

box using screws to hold Arduino Nano

box with spring latch (spring from a ink pen about18-20mm long, takes tweezers to install)

box with sliding latch.

boxes with latches......
spring latch slides in from back side, after inserted us a 3mm wide 6 to 10 mm long screw threw hole to hold spring, screw goes inside spring

slider box slides in from Arduino Nano side. use 3mm wide 6 to 10 mm long screw, slide to latch Nano and snug the screw to hold.

Program to upload to Arduino Nano

https://github.com/knud/BLTouchTest/blob/master/BLTouchTest.ino