Button Box for Thrustmaster Warthog Throttle

Shortly after finishing [my previous thing](https://www.thingiverse.com/thing:4048826) to add a button box to the Saitek X52, I took the plunge on a Thrustmaster Warthog throttle. This is a minor adaptation of that design to add a single, smaller button box on the left side of the throttle unit. Since I play in an Obutto R3volution simpit the throttle needs to mount on a small throttle plate, rather than sit on a table, so the button box needs to be secured to the bottom of the throttle unit itself.

Originally I was planning to use the mounting holes in the throttle base but to fit on my print bed I had to modify the design. The flat bottom sections of warthog_box_main go between the two metal baseplates supplied with the throttle, and is clamped in place with the throttle's baseplate holding screws (see picture #3). The safety cover for the emergency button is mounted with a couple of 2.5mm screws. All the rest is pretty straightforward.

The button box has mounting holes