Thingiverse
Cable Holder
von Main_A
15
Downloads
5
Likes
0
Makes
Designed This cable holder for my new headphones, just a simple design to reduce and manage the length of a cable.
To hold the cable extra secure, thread it through the middle slot on the first loop and the last loop.
I printed in PLA at 0.28mm layer height (as you can see in the picture my print was terrible but oh well, I am going to blame creality's PLA, I hate it so much) it's a very simple print, so the settings don't matter that much.
To hold the cable extra secure, thread it through the middle slot on the first loop and the last loop.
I printed in PLA at 0.28mm layer height (as you can see in the picture my print was terrible but oh well, I am going to blame creality's PLA, I hate it so much) it's a very simple print, so the settings don't matter that much.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
