Thingiverse
Cable Holder
por Main_A
15
Descargas
5
Likes
0
Makes
Designed This cable holder for my new headphones, just a simple design to reduce and manage the length of a cable.
To hold the cable extra secure, thread it through the middle slot on the first loop and the last loop.
I printed in PLA at 0.28mm layer height (as you can see in the picture my print was terrible but oh well, I am going to blame creality's PLA, I hate it so much) it's a very simple print, so the settings don't matter that much.
To hold the cable extra secure, thread it through the middle slot on the first loop and the last loop.
I printed in PLA at 0.28mm layer height (as you can see in the picture my print was terrible but oh well, I am going to blame creality's PLA, I hate it so much) it's a very simple print, so the settings don't matter that much.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
