Cable Organizer

This is a modified version of my cable organizer!This way you can bring a bit of order in your cable chaos Recommended filament: PLAHotend: 0,40mm Print instructions:layer height 0,20mm2 wall loopstop/bottom shells 4 layerstop/bottom shell thickness 0,80mmsparse infill 10%sparse infill pattern “gyroid”Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.Bad build plate adhesion is not related to the model. Check out my other models https://makerworld.com/en/u/1597610120Please leave me a like and a decent rating if you were satisfied, thank you in advance!