Calibration things

Several temp calibration towers of different heights, for different amounts of temp changes you may need to make in a test. A couple extrusion cubes as well.

Each tower should be printed in vase mode with no top or bottom layers, using a 0.2mm layer height, and a temp gradient change every 50 layers.

The wall thickness cube is 20mm XYZ, with 2mm walls. It should be printed 100% infill.

The solid XYZ cube is 20mm XYZ, and (if using a 0.4mm nozzle) should be printed with 2 walls & 4 top/bottom layers, for a 0.8mm shell all around. Infill should not be less than 10%, and no more than 25%.

The tube is 15mm x 150mm. I just use it to print demo examples after I found the correct temp & flowrate. Print in vase mode, no top or bottom layers.

If you don't own a set of calipers, the cube tests will show you nothing.