Thingiverse
Calibration things
door LittleMrJ
0
Downloads
1
Likes
0
Makes
Several temp calibration towers of different heights, for different amounts of temp changes you may need to make in a test. A couple extrusion cubes as well.
Each tower should be printed in vase mode with no top or bottom layers, using a 0.2mm layer height, and a temp gradient change every 50 layers.
The wall thickness cube is 20mm XYZ, with 2mm walls. It should be printed 100% infill.
The solid XYZ cube is 20mm XYZ, and (if using a 0.4mm nozzle) should be printed with 2 walls & 4 top/bottom layers, for a 0.8mm shell all around. Infill should not be less than 10%, and no more than 25%.
The tube is 15mm x 150mm. I just use it to print demo examples after I found the correct temp & flowrate. Print in vase mode, no top or bottom layers.
If you don't own a set of calipers, the cube tests will show you nothing.
Each tower should be printed in vase mode with no top or bottom layers, using a 0.2mm layer height, and a temp gradient change every 50 layers.
The wall thickness cube is 20mm XYZ, with 2mm walls. It should be printed 100% infill.
The solid XYZ cube is 20mm XYZ, and (if using a 0.4mm nozzle) should be printed with 2 walls & 4 top/bottom layers, for a 0.8mm shell all around. Infill should not be less than 10%, and no more than 25%.
The tube is 15mm x 150mm. I just use it to print demo examples after I found the correct temp & flowrate. Print in vase mode, no top or bottom layers.
If you don't own a set of calipers, the cube tests will show you nothing.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
