Thingiverse
Camera strap detachment System
door g7000_qwert
1
Downloads
5
Likes
0
Makes
[WARNING!!!]
Print this out of a high preformance material.
Any damage to or from your camera caused by this product is at your own risk.
test strength beforehand with a test print
A system to quicly attach and detach your camera strap or other carry systems.
(My print with PA12-CF broke at approximatly 50KG)
Print with 100% infill and a lot of walls on its side.
Assambly
Put the flat fork shaped piece in the slot on the main module, may take some force to click in place.
Thread the camera strap thru the hole, or a piece of rope with the Big hole version (BH).
now attach the knob to the camera using a strong piece of rope or paracord, make sure the slot it at the closed side of the main module.
done that's it
#CaptureChallenge
Print this out of a high preformance material.
Any damage to or from your camera caused by this product is at your own risk.
test strength beforehand with a test print
A system to quicly attach and detach your camera strap or other carry systems.
(My print with PA12-CF broke at approximatly 50KG)
Print with 100% infill and a lot of walls on its side.
Assambly
Put the flat fork shaped piece in the slot on the main module, may take some force to click in place.
Thread the camera strap thru the hole, or a piece of rope with the Big hole version (BH).
now attach the knob to the camera using a strong piece of rope or paracord, make sure the slot it at the closed side of the main module.
done that's it
#CaptureChallenge
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
