Thingiverse
Models
Zum Modell
Clapper Slate
670
Downloads
574
Likes
15
Makes
Clapper Slate (aka Clapperboard) is a single print, with no assembly required.
I have been looking for a clapper slate for a while and could not find a authentic looking one, so I decided to create one base on a typical cliche design.
The print needs support which can be easily removed by pilers. To set the joint free, insert a cutter/knife into the gap and twist to break the support apart. Model paint is recommended but a permanent black marker will do just fine. White board marker works for writing on the surface and should be erasable.
Default size is 13cm by 11cm.
New Clapper Slate XL uploaded
Size is 22cm by 18cm
I have been looking for a clapper slate for a while and could not find a authentic looking one, so I decided to create one base on a typical cliche design.
The print needs support which can be easily removed by pilers. To set the joint free, insert a cutter/knife into the gap and twist to break the support apart. Model paint is recommended but a permanent black marker will do just fine. White board marker works for writing on the surface and should be erasable.
Default size is 13cm by 11cm.
New Clapper Slate XL uploaded
Size is 22cm by 18cm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
