Thingiverse
Clapper Slate
671
Downloads
577
Likes
15
Makes
Clapper Slate (aka Clapperboard) is a single print, with no assembly required.
I have been looking for a clapper slate for a while and could not find a authentic looking one, so I decided to create one base on a typical cliche design.
The print needs support which can be easily removed by pilers. To set the joint free, insert a cutter/knife into the gap and twist to break the support apart. Model paint is recommended but a permanent black marker will do just fine. White board marker works for writing on the surface and should be erasable.
Default size is 13cm by 11cm.
New Clapper Slate XL uploaded
Size is 22cm by 18cm
I have been looking for a clapper slate for a while and could not find a authentic looking one, so I decided to create one base on a typical cliche design.
The print needs support which can be easily removed by pilers. To set the joint free, insert a cutter/knife into the gap and twist to break the support apart. Model paint is recommended but a permanent black marker will do just fine. White board marker works for writing on the surface and should be erasable.
Default size is 13cm by 11cm.
New Clapper Slate XL uploaded
Size is 22cm by 18cm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
