Slicer Discord
Cleat – 3D printable model from Thingiverse Thingiverse

Cleat

by Marlyn
129 Downloads
83 Likes
2 Makes
Go to Model
Rope Cleat - for one-handed 'tie-off-the-rope' action - like when you're pulling your bicycle or 'heavy thing' to the ceiling and need a hand on the 'thing' at the same moment you need to latch the rope.
I mount this on the side of the 2x8 joist under the peak of the garage roof - in the middle, where the pulley is - and too high to reach to tie off a rope.

The little bump-with-a-hole in the cam part is for attaching a rubber band or spring - it helps the cam grab the rope.

There are only three things to add - two screws and a rubber ban or spring

I have not tried it, but I think just scaling it down should make it work better for smaller rope.
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection