Thingiverse
Cleat
door Marlyn
129
Downloads
83
Likes
2
Makes
Rope Cleat - for one-handed 'tie-off-the-rope' action - like when you're pulling your bicycle or 'heavy thing' to the ceiling and need a hand on the 'thing' at the same moment you need to latch the rope.
I mount this on the side of the 2x8 joist under the peak of the garage roof - in the middle, where the pulley is - and too high to reach to tie off a rope.
The little bump-with-a-hole in the cam part is for attaching a rubber band or spring - it helps the cam grab the rope.
There are only three things to add - two screws and a rubber ban or spring
I have not tried it, but I think just scaling it down should make it work better for smaller rope.
I mount this on the side of the 2x8 joist under the peak of the garage roof - in the middle, where the pulley is - and too high to reach to tie off a rope.
The little bump-with-a-hole in the cam part is for attaching a rubber band or spring - it helps the cam grab the rope.
There are only three things to add - two screws and a rubber ban or spring
I have not tried it, but I think just scaling it down should make it work better for smaller rope.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!