Thingiverse
Comma3X Offset Mount - Parametric
von Gallapagos
0
Downloads
0
Likes
0
Makes
I mounted my comma3 a tad off center, due to this the car hugged the right hand side of the road a lot. To alleviate this, I made a mount to shift the unit further right (for me I needed -30mm). I've iterated on that original unit to make one thats parametric! Load this file into fusion and adjust the 'offset parameter' to whatever you want.
Car is hugging **left** - Unit should be moved **left**, offset should be **positive**
Car is hugging **right** - Unit should be moved **right**, offset should be **negative**
Be sure to print this in PETG/ABS/ASA only! Any other filament will melt/deform in the heat (especially PLA, do **not** use PLA).
Car is hugging **left** - Unit should be moved **left**, offset should be **positive**
Car is hugging **right** - Unit should be moved **right**, offset should be **negative**
Be sure to print this in PETG/ABS/ASA only! Any other filament will melt/deform in the heat (especially PLA, do **not** use PLA).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
