Thingiverse
Comma3X Offset Mount - Parametric
por Gallapagos
0
Descargas
0
Likes
0
Makes
I mounted my comma3 a tad off center, due to this the car hugged the right hand side of the road a lot. To alleviate this, I made a mount to shift the unit further right (for me I needed -30mm). I've iterated on that original unit to make one thats parametric! Load this file into fusion and adjust the 'offset parameter' to whatever you want.
Car is hugging **left** - Unit should be moved **left**, offset should be **positive**
Car is hugging **right** - Unit should be moved **right**, offset should be **negative**
Be sure to print this in PETG/ABS/ASA only! Any other filament will melt/deform in the heat (especially PLA, do **not** use PLA).
Car is hugging **left** - Unit should be moved **left**, offset should be **positive**
Car is hugging **right** - Unit should be moved **right**, offset should be **negative**
Be sure to print this in PETG/ABS/ASA only! Any other filament will melt/deform in the heat (especially PLA, do **not** use PLA).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
