Thingiverse
Conscendo Evolution table stand
door alpo16000
1
Downloads
2
Likes
0
Makes
Conscendo Evolution table stand
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
alpo16000 publiceert ook op
24 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
