Thingiverse
Conscendo Evolution table stand
von alpo16000
1
Downloads
2
Likes
0
Makes
Conscendo Evolution table stand
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
alpo16000 veröffentlicht auch auf
24 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
