Thingiverse
Conscendo Evolution table stand
by alpo16000
1
Downloads
2
Likes
0
Makes
Conscendo Evolution table stand
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
alpo16000 also publishes on
24 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
