Thingiverse
Control Panel Easel
von TodoRojo
5
Downloads
7
Likes
0
Makes
A very simple easel for holding control panels for the astro city (and probably other cabs as well). I wanted a way to store my control panels safely and keep them populated. This is the result.
cp-easel is just a standard easel.
cp-assembly-stand is a stand with a 20 degree angle. This can be useful for populating a panel.
cp-wall-mnt is a wall mount. It's easiest if you put the top of the panel in first and then the bottom. The screws it is designed for are #10 flat machined screws. The holes are about .5" deep. Basically, buy some #10 screws with drywall anchors and you should be ok. My panel has a Seimitsu LS-32 mounted on it and the stick had plenty of clearance from the wall.
Turn them sideways and lay them flat to print.
cp-easel is just a standard easel.
cp-assembly-stand is a stand with a 20 degree angle. This can be useful for populating a panel.
cp-wall-mnt is a wall mount. It's easiest if you put the top of the panel in first and then the bottom. The screws it is designed for are #10 flat machined screws. The holes are about .5" deep. Basically, buy some #10 screws with drywall anchors and you should be ok. My panel has a Seimitsu LS-32 mounted on it and the stick had plenty of clearance from the wall.
Turn them sideways and lay them flat to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
