Thingiverse
Control Panel Easel
por TodoRojo
5
Descargas
7
Likes
0
Makes
A very simple easel for holding control panels for the astro city (and probably other cabs as well). I wanted a way to store my control panels safely and keep them populated. This is the result.
cp-easel is just a standard easel.
cp-assembly-stand is a stand with a 20 degree angle. This can be useful for populating a panel.
cp-wall-mnt is a wall mount. It's easiest if you put the top of the panel in first and then the bottom. The screws it is designed for are #10 flat machined screws. The holes are about .5" deep. Basically, buy some #10 screws with drywall anchors and you should be ok. My panel has a Seimitsu LS-32 mounted on it and the stick had plenty of clearance from the wall.
Turn them sideways and lay them flat to print.
cp-easel is just a standard easel.
cp-assembly-stand is a stand with a 20 degree angle. This can be useful for populating a panel.
cp-wall-mnt is a wall mount. It's easiest if you put the top of the panel in first and then the bottom. The screws it is designed for are #10 flat machined screws. The holes are about .5" deep. Basically, buy some #10 screws with drywall anchors and you should be ok. My panel has a Seimitsu LS-32 mounted on it and the stick had plenty of clearance from the wall.
Turn them sideways and lay them flat to print.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
