Thingiverse
Cryptex_6
von Chiyetanka
21
Downloads
9
Likes
0
Makes
Big thanks to [CloudJ] for original post!
The main change I made is to the width of the gaps in the "outer" tube. Made 'em wider by about 1mm total. This allows "inner" tube to fit nicely and everything spins easy. I needed this to spin easy enough for both the very young and the very old. Works great.
See my 4-ring version here: https://www.thingiverse.com/thing:5696580
In this remix I've adjusted the nubs and the tube-dimensions as my prints were coming out too tight and gap widths. Now it's smooth and easy. NO SANDING NEEDED.
Print:
(1) inner
(1) outer
(6) locks
(6) rings
I'm printing on Draft mode without supports.
The main change I made is to the width of the gaps in the "outer" tube. Made 'em wider by about 1mm total. This allows "inner" tube to fit nicely and everything spins easy. I needed this to spin easy enough for both the very young and the very old. Works great.
See my 4-ring version here: https://www.thingiverse.com/thing:5696580
In this remix I've adjusted the nubs and the tube-dimensions as my prints were coming out too tight and gap widths. Now it's smooth and easy. NO SANDING NEEDED.
Print:
(1) inner
(1) outer
(6) locks
(6) rings
I'm printing on Draft mode without supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
