Thingiverse
Cryptex_6
por Chiyetanka
21
Descargas
9
Likes
0
Makes
Big thanks to [CloudJ] for original post!
The main change I made is to the width of the gaps in the "outer" tube. Made 'em wider by about 1mm total. This allows "inner" tube to fit nicely and everything spins easy. I needed this to spin easy enough for both the very young and the very old. Works great.
See my 4-ring version here: https://www.thingiverse.com/thing:5696580
In this remix I've adjusted the nubs and the tube-dimensions as my prints were coming out too tight and gap widths. Now it's smooth and easy. NO SANDING NEEDED.
Print:
(1) inner
(1) outer
(6) locks
(6) rings
I'm printing on Draft mode without supports.
The main change I made is to the width of the gaps in the "outer" tube. Made 'em wider by about 1mm total. This allows "inner" tube to fit nicely and everything spins easy. I needed this to spin easy enough for both the very young and the very old. Works great.
See my 4-ring version here: https://www.thingiverse.com/thing:5696580
In this remix I've adjusted the nubs and the tube-dimensions as my prints were coming out too tight and gap widths. Now it's smooth and easy. NO SANDING NEEDED.
Print:
(1) inner
(1) outer
(6) locks
(6) rings
I'm printing on Draft mode without supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
