Thingiverse
Customizable Optics Table Servo Mount
por Emanresu
53
Descargas
19
Likes
0
Makes
Customizable hobby servo mount for use with optics breadboard.
The defaults are designed to mount a micro-servo (Hitech HS-65, but should fit other micro-servos as well) on an optics breadboard. The base holes are 2" apart, designed to accomodate 1/4-20 screws. The servo mount centers the shaft of the servo between the two base holes.
Using customizer you can easily tweak the design to fit pretty much any hobby servo.
The defaults are designed to mount a micro-servo (Hitech HS-65, but should fit other micro-servos as well) on an optics breadboard. The base holes are 2" apart, designed to accomodate 1/4-20 screws. The servo mount centers the shaft of the servo between the two base holes.
Using customizer you can easily tweak the design to fit pretty much any hobby servo.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!