Thingiverse
Customizable Optics Table Servo Mount
von Emanresu
53
Downloads
19
Likes
0
Makes
Customizable hobby servo mount for use with optics breadboard.
The defaults are designed to mount a micro-servo (Hitech HS-65, but should fit other micro-servos as well) on an optics breadboard. The base holes are 2" apart, designed to accomodate 1/4-20 screws. The servo mount centers the shaft of the servo between the two base holes.
Using customizer you can easily tweak the design to fit pretty much any hobby servo.
The defaults are designed to mount a micro-servo (Hitech HS-65, but should fit other micro-servos as well) on an optics breadboard. The base holes are 2" apart, designed to accomodate 1/4-20 screws. The servo mount centers the shaft of the servo between the two base holes.
Using customizer you can easily tweak the design to fit pretty much any hobby servo.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
