Thingiverse
Customizable Rosette
von Robo
8
Downloads
5
Likes
0
Makes
Rosette for pipes for waterworks.
All the rosettes that I can get in the stores are ugly. So I needed a custom one.
Useless fact:
I used a cylinder with variable number of sides for the hole. I needed this to fit to a hexagonal nut. But OpenScad uses the center-to-tip size for diameter. Usually hex (and square) sizes are side-to-side. So I had to divide the radius by cos(180/NumberOfSidesForHole). Therefore this works for square, hexagonal, 8-sides 12 sided and round holes. I'm proud of myself, but noone will ever notice the true beauty of it.
All the rosettes that I can get in the stores are ugly. So I needed a custom one.
Useless fact:
I used a cylinder with variable number of sides for the hole. I needed this to fit to a hexagonal nut. But OpenScad uses the center-to-tip size for diameter. Usually hex (and square) sizes are side-to-side. So I had to divide the radius by cos(180/NumberOfSidesForHole). Therefore this works for square, hexagonal, 8-sides 12 sided and round holes. I'm proud of myself, but noone will ever notice the true beauty of it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
