Thingiverse
Customizable Rosette
by Robo
8
Downloads
5
Likes
0
Makes
Rosette for pipes for waterworks.
All the rosettes that I can get in the stores are ugly. So I needed a custom one.
Useless fact:
I used a cylinder with variable number of sides for the hole. I needed this to fit to a hexagonal nut. But OpenScad uses the center-to-tip size for diameter. Usually hex (and square) sizes are side-to-side. So I had to divide the radius by cos(180/NumberOfSidesForHole). Therefore this works for square, hexagonal, 8-sides 12 sided and round holes. I'm proud of myself, but noone will ever notice the true beauty of it.
All the rosettes that I can get in the stores are ugly. So I needed a custom one.
Useless fact:
I used a cylinder with variable number of sides for the hole. I needed this to fit to a hexagonal nut. But OpenScad uses the center-to-tip size for diameter. Usually hex (and square) sizes are side-to-side. So I had to divide the radius by cos(180/NumberOfSidesForHole). Therefore this works for square, hexagonal, 8-sides 12 sided and round holes. I'm proud of myself, but noone will ever notice the true beauty of it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
