Thingiverse
Customizable Slope Test
von mrkmg
47
Downloads
22
Likes
0
Makes
A customizer friendly slope test generator file.
Use this file to determine how much edge you can handle at specific settings on your printer.
Here is how I use it. When I have a long running print to do that has overhangs, I will decide what quality/temp/etc I am using for the print. I will then load this file up and run various slopes to determine where I really need and do not need support structures.
I print this with no support, no raft, as is at whatever settings my up-coming print will be. This way, I can see what both positive and negative slopes will look like.
Customizer makes it easy to change the number of test slopes and angles. I would not shrink the height to ensure there is enough slope to see any defects which may show up.
Use this file to determine how much edge you can handle at specific settings on your printer.
Here is how I use it. When I have a long running print to do that has overhangs, I will decide what quality/temp/etc I am using for the print. I will then load this file up and run various slopes to determine where I really need and do not need support structures.
I print this with no support, no raft, as is at whatever settings my up-coming print will be. This way, I can see what both positive and negative slopes will look like.
Customizer makes it easy to change the number of test slopes and angles. I would not shrink the height to ensure there is enough slope to see any defects which may show up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
