Cyclone

This is a small cyclone project for working with my machines from PROXXON. He will try to separate the shavings in order not to hammer down the filters of my vacuum cleaner.
I had to divide the model into 3 parts to fit in my printer. The principle of operation is evident from the figure. All parts are glued together. On the bottom there are holes for thread M6. The cyclone is mounted on the lid of the bucket, where most of the shavings will be collected.
The connecting dimension is 50 mm.

add
I added a cylindrical spacer of 50 mm. and a confuser with an angle of 20 ° and a large confuser with an angle of 15°.
Added confuser height of 199 mm. For those who have a printer working height of 200 mm.
The ratio of the height of the cylindrical part to the diameter is strongly influenced by the work. Ideally 1.6 is the golden ratio;)

Это небольшой проект циклона для работы с моими станочками от PROXXON. Он позволяет отделить стружку, чтобы сильно не забивать фильтр моего пылесоса.