Dragon Tree

Dragon Tree made to be printed in Vase Mode (with holes to let the light through)

Can be used as a table decoration, tree ornament, lamp

---

Short video
https://www.instagram.com/p/C0yh3mmNow8/

---

For a tree decoration you have two options

One is just simply tie a thread just below the star

The second is like on the photos
You will need to cut off the tip of the print (just a few mm) to make a hole for a thread (rather thicker, like a yarn)
The easiest way to put a thread in the hole is to use a big needle. Put a thread in the needle's hole making a loop on one side with two ends on the other side. Then push a needle from the bottom to top through the hole in the print and take of the needle
After that make a few knots (one on another, should be bigger than a hole) to tie both ends together and secure the thread

---

**More XMAS decoration in Collection:**
https://www.thingiverse.com/C47_3D/collections/17109714/things

---