Thingiverse
Drum
por AMAZ-3D
65
Descargas
31
Likes
2
Makes
REV1 | (Void)
REV 2 | (one piece)
- No support needed
- Added a shape to increase comfort when playing with the drum
- Added fixture to use with a rope
- Top skin is 0.8 mm
- Print with the top skin laying down
- Added extension that can be stacked as required. The extension should be bonded using contact glue.
REV 3 | (interchangeable)
- Modify the design so that the top skin is removable. It is built with a self locking clip.
- Pros: will use less plastic if the drum gets damaged.
- Cons: risk of affecting the sound.
REV 4 | (3D printable on a 200 X 200 mm bed)
- Same feature as above!
Thank you to provide feedback and request for special add-on
General information:
- Average noise level 80 DB
- Peak noise level: 120 DB
- It could be interresting to use Ninjaflex for the first 2 layers and then PLA
REV 2 | (one piece)
- No support needed
- Added a shape to increase comfort when playing with the drum
- Added fixture to use with a rope
- Top skin is 0.8 mm
- Print with the top skin laying down
- Added extension that can be stacked as required. The extension should be bonded using contact glue.
REV 3 | (interchangeable)
- Modify the design so that the top skin is removable. It is built with a self locking clip.
- Pros: will use less plastic if the drum gets damaged.
- Cons: risk of affecting the sound.
REV 4 | (3D printable on a 200 X 200 mm bed)
- Same feature as above!
Thank you to provide feedback and request for special add-on
General information:
- Average noise level 80 DB
- Peak noise level: 120 DB
- It could be interresting to use Ninjaflex for the first 2 layers and then PLA
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
