Drum

REV1 | (Void)

REV 2 | (one piece)
- No support needed
- Added a shape to increase comfort when playing with the drum
- Added fixture to use with a rope
- Top skin is 0.8 mm
- Print with the top skin laying down
- Added extension that can be stacked as required. The extension should be bonded using contact glue.

REV 3 | (interchangeable)
- Modify the design so that the top skin is removable. It is built with a self locking clip.
- Pros: will use less plastic if the drum gets damaged.
- Cons: risk of affecting the sound.

REV 4 | (3D printable on a 200 X 200 mm bed)
- Same feature as above!
Thank you to provide feedback and request for special add-on

General information:
- Average noise level 80 DB
- Peak noise level: 120 DB
- It could be interresting to use Ninjaflex for the first 2 layers and then PLA