MakerWorld
Other Hobby & DIY
Zum Modell
E Class Model Rocket
156
Downloads
91
Likes
78
Makes
This rocket uses a E12-6 Estes motor. It is made for a ¼ in launch rod.Can be printed in pla, abs, and petg.I used abs for the rocket and pla for the camera mount, but petg would be the best for the rocket.Printed with supports. Assembly can be found in the documentation. All the materials listed here were used by me when i launched the rocket.Materials you need:Estes E12-6 Engine/Motor (Cheapest at hobby lobby)Kevlar cord (550 lbs, length does not matter)Parachute (any 18 in or bigger parachute will work)eye hooks (any 2.5in eye hooks with a 4.2mm wire diameter)Launch Rod (any ¼ in rod, you can also buy the Porta-Pad E which includes the rod)Recovery wadding (You can also try using the regular wadding or a parachute protector) For Launching:<a target="_blank" rel="noopener noreferrer ugc
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
