Thingiverse
Ender 3 Pro Bed Level Knobs
por CB_ATX
541
Descargas
288
Likes
1
Makes
I wanted bed level knobs that matched by z-rod and extruder knobs so here they are.
Press fit for a 4mm nut. Use a washer where the knob will contact the metal.
1 gram lighter than stock, same diameter but taller. Printed in PLA at 20% infill.
I used no supports for the nut cavity and it printed fine just needed a little clean up.
Enjoy!
Press fit for a 4mm nut. Use a washer where the knob will contact the metal.
1 gram lighter than stock, same diameter but taller. Printed in PLA at 20% infill.
I used no supports for the nut cavity and it printed fine just needed a little clean up.
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
