Thingiverse
Ender 3 Pro Bed Level Knobs
door CB_ATX
541
Downloads
288
Likes
1
Makes
I wanted bed level knobs that matched by z-rod and extruder knobs so here they are.
Press fit for a 4mm nut. Use a washer where the knob will contact the metal.
1 gram lighter than stock, same diameter but taller. Printed in PLA at 20% infill.
I used no supports for the nut cavity and it printed fine just needed a little clean up.
Enjoy!
Press fit for a 4mm nut. Use a washer where the knob will contact the metal.
1 gram lighter than stock, same diameter but taller. Printed in PLA at 20% infill.
I used no supports for the nut cavity and it printed fine just needed a little clean up.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
