Thingiverse
EV cable caddy
von northerncore
4
Downloads
10
Likes
0
Makes
Easy to print charger caddy to hang your cable hanging when not charging your EV.
this is a common "mennekes type 2" connector.
Included a weep-hole to drain out water against the wall.
I printed this with 45% infill and 5 walls/shells to make it strong.
made it so i could print it on my small Flashorge adv. 3.
this is a common "mennekes type 2" connector.
Included a weep-hole to drain out water against the wall.
I printed this with 45% infill and 5 walls/shells to make it strong.
made it so i could print it on my small Flashorge adv. 3.
northerncore veröffentlicht auch auf
19 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
