Thingiverse
EV cable caddy
door northerncore
4
Downloads
10
Likes
0
Makes
Easy to print charger caddy to hang your cable hanging when not charging your EV.
this is a common "mennekes type 2" connector.
Included a weep-hole to drain out water against the wall.
I printed this with 45% infill and 5 walls/shells to make it strong.
made it so i could print it on my small Flashorge adv. 3.
this is a common "mennekes type 2" connector.
Included a weep-hole to drain out water against the wall.
I printed this with 45% infill and 5 walls/shells to make it strong.
made it so i could print it on my small Flashorge adv. 3.
northerncore publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
