Thingiverse
Extendable Cup
von Morast
36
Downloads
33
Likes
0
Makes
Note:
This cup DOES NOT hold any Liquids !!!
Wait.... Yes it does ! But not for long ;)
I Suggest a Layer Height of at least 0.1mm.
The Photo shows my 1st attempt with 0.25mm. Not good....
This cup DOES NOT hold any Liquids !!!
Wait.... Yes it does ! But not for long ;)
I Suggest a Layer Height of at least 0.1mm.
The Photo shows my 1st attempt with 0.25mm. Not good....
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
