Thingiverse
Extruder Loop
por Alf_Arobase
158
Descargas
131
Likes
1
Makes
this is an extruder named Loop:
- for NEMA17 stepped motor
- standart 50mm M4 fixation holes at the bottom
- RichRap quick-fit compatible
- J-head/e3d nozzle buit-in holder
it's mainly a variant of http://www.thingiverse.com/thing:28916 and Greg's Wade reloaded
what is different then?
- Tiltable M4 idler-screws really open (by 40°) and have a stronger nuts housing
- filament is closer to the M8 drive bolt than olekdh version (3.7mm center-to-center)
- oblong hole for motor positionning are wider, allowing to disangage the gear for easier assembly
- add a support for drive screw bearing surface.
- it's fully redesigned in Solidworks 2013
see instruction for more informations and changelog
feel free to make suggestions to improve this design!
- for NEMA17 stepped motor
- standart 50mm M4 fixation holes at the bottom
- RichRap quick-fit compatible
- J-head/e3d nozzle buit-in holder
it's mainly a variant of http://www.thingiverse.com/thing:28916 and Greg's Wade reloaded
what is different then?
- Tiltable M4 idler-screws really open (by 40°) and have a stronger nuts housing
- filament is closer to the M8 drive bolt than olekdh version (3.7mm center-to-center)
- oblong hole for motor positionning are wider, allowing to disangage the gear for easier assembly
- add a support for drive screw bearing surface.
- it's fully redesigned in Solidworks 2013
see instruction for more informations and changelog
feel free to make suggestions to improve this design!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!