Thingiverse
Extruder Loop
door Alf_Arobase
158
Downloads
131
Likes
1
Makes
this is an extruder named Loop:
- for NEMA17 stepped motor
- standart 50mm M4 fixation holes at the bottom
- RichRap quick-fit compatible
- J-head/e3d nozzle buit-in holder
it's mainly a variant of http://www.thingiverse.com/thing:28916 and Greg's Wade reloaded
what is different then?
- Tiltable M4 idler-screws really open (by 40°) and have a stronger nuts housing
- filament is closer to the M8 drive bolt than olekdh version (3.7mm center-to-center)
- oblong hole for motor positionning are wider, allowing to disangage the gear for easier assembly
- add a support for drive screw bearing surface.
- it's fully redesigned in Solidworks 2013
see instruction for more informations and changelog
feel free to make suggestions to improve this design!
- for NEMA17 stepped motor
- standart 50mm M4 fixation holes at the bottom
- RichRap quick-fit compatible
- J-head/e3d nozzle buit-in holder
it's mainly a variant of http://www.thingiverse.com/thing:28916 and Greg's Wade reloaded
what is different then?
- Tiltable M4 idler-screws really open (by 40°) and have a stronger nuts housing
- filament is closer to the M8 drive bolt than olekdh version (3.7mm center-to-center)
- oblong hole for motor positionning are wider, allowing to disangage the gear for easier assembly
- add a support for drive screw bearing surface.
- it's fully redesigned in Solidworks 2013
see instruction for more informations and changelog
feel free to make suggestions to improve this design!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!